3 x Screw Bolt for the Fits the TaylorMade M3 / M4 / M5 / M6 / SIM / SIM 2 / Stealth / Stealth 2 and Qi10

This is the standard Titanium screw that fits the Drivers  and fairways 0.335 Adapter Only

Comes with the rubber washer which if installed correctly should hold the screw in the driver head when the shaft is removed if installed properly.

THIS IS FOR 3 x SCREWS / BOLTS ONLY

The way to insert the washer.

Balance the washer on the top of the adaptor and then insert the club head upside down over the washer/adaptor and then push the screw through the bottom of the head and locate the washer/adaptor on the inside of the hosel and screw carefully until the thread catches. This will stop the screw from falling OUT when removing the head when changing to higher, lower etc!

The TaylorMade M3, M4, M5, M6, Sim, Sim2 head screw differs from the old version. TaylorMade have changed the opening at the bottom of the head, which will not accept the Old Standard Screw.